
Flight Systems Electronics Group
Engine Control Module/Unit (ECM/ECU) - 2007.5 Dodge 6.7L Cummins - 4945387 FSR4945387
2008 Dodge 6.7L Cummins Diesel
Units are programmed for specific year models and type of transmission. If you have any troubles with choosing of application please give us a call on our toll free number and we will get you the correct module. 1(800)823-4444. Units are programmed and tested by order and have a typical build time of 3-5 days before shipment.
Warning: The process of rebuilding the ECU and/or re-flashing the software sets the programmingback to factory settings. This process does not keep custom tuning or programming done to the unit prior.
Please be aware that core availability for remanufacture and reprogram can change overnight. If you must be sure of availability, please give us a call with your vehicle and engine information handy so we can find out if a core is available. You may also waive the core charge and send in your ECU/ECM for rebuild.
Built to Order - ECM's are NOT plug-n-play. They must be built and programmed for EACH specific vehicle. Many ECM's have low to non-existent core availability so you may need to have yours rebuilt.
Refundable Core Charge: $250
More InformationPart # FSR4980611
Now offering the Cummins 6.7L ECU for 6.7L diesel Cummins trucks. These are thoroughly re-manufactured and fully programmed for your specific vehicle. All units go through tri-temperature testing and quality inspections. For further information, please contact us.
Units are flashed with programming for specific year and transmission type. Some vehicles have VERY specific programming so when ordering we need as much information as possible to ensure operation.
When "Choosing Product Options" to the right, under the Core Charge there is a text box labeled "Additional Info Necessary". Please collect as much of the information listed out below as you can and type it into this area before adding to cart. If this is left blank or incomplete, we will contact you soon after your order to get this information.
Information we need:
The Valve Cover Reference Number is located on the driver side of the valve cover and starts with a "53" and ends with 2 letters as shown in the photo below.
For vehicles with Sentry Key Immobilizer Modules (SKIM) - There is a possibility that the unit will have codes appear for the immobilizer circuit. You will need to allow for 3 drive cycles for this to go away (learning procedure for SKIM Immobilizer) only on units with SKIM. Any clear DTC will interrupt the learning procedure and the unit will no longer receive SKIM info. The unit will need to be reflashed at this point. This information will be printed on a yellow or red sheet of paper and included in the box.
WARNING : This product can expose you to chemicals including arsenic, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov