BDS Suspension

4" Suspension Lift Kit - 2011-2016 Ford F250 / F350 4WD Diesel 588H

0 review Write a Review
MPN: 588H
$1,159.79
Free Ground Shipping (Continental US)

Short Description

Hurry up! Current stock:
4" Suspension Lift Kit - 2011-2016 Ford F250 / F350 4WD Diesel

Part # 588H

This kit centered around two Pro-Ride Coil Springs. The box kit includes two new radius arm drop brackets to put the stock radius arm back at factory angle which will maintain your stock driving characteristics.

The kit also comes with anti-sway bar drop brackets, a dropped pitman arm for steering angle correction, a track bar relocation bracket to properly center your axle and bump stop extension.

The rear is lifted via a 5" block kit and eliminates the factory block.

  • Tire & Wheel Combinations
  • 35" x 12.50" w/17 x 9 and 4.5" back spacing
  • 35" x 12.50" w/18 x 9 and 4.5" back spacing
  • 35" x 12.50" w/20 x 9 and 4.5" back spacing
  • *Trimming may be required*

  • Est. Installation: 8 hours
  • Difficulty Level (easy 1 - 5 complicated): 3

Qty Part# Description
1 013413 11 Ford F250/350 4in Box kit
1 013519 05-up F250/350 5in Rear W/o Ovld
1 033411 Coil Spring Box Kit (Diesel)
2 85700 BDS NX2 Shock
2 85760 NX² Shock Absorber

Important Kit Notes
  • 1. Removal of factory block required. Rear add a leaf is required for models equipped with factory 3-7/8" block for level to tail high stance. Single add-a-leaf kit # 113218 recommended for more level stance - Dual add-a-leaf kit # 113209 recommended for tail high stance. (Add-a-leafs do not apply to rear leaf spring equipped systems)
  • 2. Front exhaust modification may be required to clear front drive shaft (gas only).
  • 3. If equipped with 2-piece driveshaft, a driveshaft alignment kit may be required.
  • 4. Although extremely rare, front and/or rear driveline vibration may occur.
  • 5. If equipped with rear sway bar, #123009 required.
  • 6. U-bolts will not work on dually.

WARNING : This product can expose you to chemicals including arsenic, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov

BDS Suspension - "No Fine Print Warranty"

BDS stands behind its products and that's evident by their No Fine Print Warranty. This warranty protects the original retail purchaser against breakage, bending, sagging, or any other usage failure. We don't care if you jumped your truck off a cliff, lit it on fire, rolled it down a hill, installed Chevy parts on your Ford, or even if you didn't read the instructions and cross threaded a bolt with too many Ugga Duggas! This "no fine print" lifetime replacement warranty extends to cover all BDS hard parts and includes a lifetime warranty on bushings! Exclusions would be product finish and wearable items as described below. All warranties require the customer to provide a Proof of purchase including Name, product, purchase date and price paid.

No Fine Print Warranty ~ If you are the original purchaser of any BDS product and it breaks, they will give you a new part. Period.


Wearable Parts | Limited Lifetime Warranty

BDS NX2 Series Shocks and BDS/Fox Performance Series Shocks:
Shock oil seals are not covered by this Limited Lifetime Warranty because they are subject to wear over time and use. At BDS's discretion, leaking shock seals less than 2 years from date of purchase, free from contamination, damage, or abnormal seal wear due to misuse can be considered for repair or replacement under warranty. A shock absorber is a wear item and over time will experience diminished damping resistance due to normal component wear. This is not a defect in material or workmanship and is therefore not warrantable. Defects in material and workmanship do not include such things as dented cylinders or bent rods caused by obvious side impact, rust or corrosion.

Fox Proprietary Shocks and Coil Overs:
Fox Proprietary parts are covered by their warranty and are not included in the BDS Warranty. BDS may offer to assist with the warranty of defective product, at our discretion. Other warranty concerns should be handled through the Fox Service program. Leaking shock seals less than 1 year from date of purchase, free from contamination, damage, or abnormal seal wear due to misuse can be considered for Warranty. FOX service information can be
found here:  https://www.ridefox.com/service.php?m=truck

Ball Joints and Tie Rod Ends:
These items are subject to normal wear over time. However, Ball Joints and Tie Rod ends less than 3 years from the date of purchase, that have been properly greased, maintained, and do not show signs of abnormal use can be considered for warranty.

BDS Suspension's obligation under all warranties is limited to the repair or replacement, at BDS's option, of the defective material. BDS will cover the cost of ground shipping on warranty items, and a return shipping label if we require the warranty part to be returned to us. Any cost of removal, installation or reinstallation, expedited freight charges, incidental or consequential damages are expressly excluded from these warranties. Proof of purchase is required for all warranty claims.