South Bend Clutch 400hp Single Disc (Repair/Replacement) - 1988-2004 Dodge 5.9L Cummins 13125-OR

400HP, 800 torque - Flywheel Not Included

Does not fit Dodge (OEM) stock flywheel: This clutch kit replaces South Bend Clutch 13125-OK Clutch Kit only!

Repair / Replacement Clutch Kit for South Bend Clutch Kit # 13125-OK 400HP which converts stock 12 1/4" to 13-1.25" clutch. Comes with everything you need to do the job, including Throw Out Bearing and Heavy duty roller pilot bearing (already installed).

This South Bend Dyna Max kit features a performance organic lining on a marcelled fin. The pressure plate is modified for higher plate load and smoothness of engagement. This clutch was designed to cure premature disc failure due to high horse power and heavy hauling in the 5 speed and early 6 speed NON-High Output 12 1/4" clutches. We have taken the 13" High Output clutch and modified it to accept the 1 1/4" input shaft. By doing this, it enabled us to offer a disc center that is 2-3 times larger and stronger then can be provided in the 12 1/4" clutch kits. Rated to handle up to 400 horsepower & 800 ft. lbs. of torque.

• 1988-1993 Getrag 5 Speed
• 1994-2004 NV4500 5 Speed
• 1999-2000.5 NV5600 6 Speed without High Output 235hp

NOTE: It's very important to Break-In your clutch with 500 miles of stop and go driving before you pull a load. Your clutch will last longer if you avoid down-shifting whenever possible. Down-shifting flexes the pressure plate, causing uneven wear. Just remember, Use your breaks instead--they're are a lot less expensive to replace!

Warranty: 1 year, 12,000 miles, whichever comes first, manufacturer defects only.