South Bend Clutch
South Bend Clutch 475hp Single Disc (Repair/Replacement) - 1988-2004 Dodge 5.9L Cummins 13125-OFER
475hp 1000 TQ 13" Organic-Feramic Disc Clutch
This South Bend Clutch Converts stock 12 1/4" to 13-1.25" clutch. Complete Clutch Replacement Kit, comes with everything you need to do the job, including Flywheel, Throw Out Bearing, Stock Needle Pilot Bearing, and alignment tool. *88-93 Getrag trans must re-use stock crank bolts*
This Dyna Max kit features a variation from organic to organic and feramic or all feramic linings with marcelled fins. The pressure plate is modified for higher plate load and smoothness of engagement. This clutch was designed to cure premature disk failure due to high horse power and heavy hauling in the 5 speed and early 6 speed non-ETH 12 1/4" clutches. We have taken the 13" ETH clutch and modified it to accept the 1 1/4" input shaft. By doing this, it enabled us to offer a disk center that is 2-3 times larger and stronger than can be provided in the 12 1/4" clutch kits. This kit comes with a flywheel, re-drilled and refaced to accept the larger clutch and is rated to handle up to 475 horsepower & 1000 ft. lbs. of torque. Years 1988-2004 5 speed & 6 speed non-ETH.
NOTE: It's very important to Break-In your clutch with 500 miles of stop and go driving before you pull a load. Your clutch will last longer if you avoid down-shifting whenever possible. Down-shifting flexes the pressure plate, causing uneven wear. Just remember, Use your breaks instead--they're are a lot less expensive to replace!
Warranty: 1 year, 12,000 miles, whichever comes first, manufacturer defects only.
WARNING : This product can expose you to chemicals including arsenic, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov