Reviva - Drop-In Engine with Head-Studs Upgrade - International VT365
Part # 59G4D175IPS
ABOUT THE REVIVA VT365
- All Reviva engines are assembled in the USA.
- Blocks, heads and crankshafts are 100% magnaflux tested to avoid cracked components.
- Crankshaft is checked for size, reground, if necessary, and micropolished to OEM specifications.
- Camshaft is checked for wear, reground as necessary, and micropolished to OEM specifications.
- Connecting rods have new bushings installed and both large and small end are remachined to OEM specifications.
- All connecting rods are de-magnetized.
- All heads get new valves and are vacuum tested to ensure the quality of the valve job. All heads are pressure tested.
- Core plugs are 100% stainless steel to avoid corrosion.
- Reviva replaces 100% internal wear items including rings, bearings, bushings, gaskets and seals.
All of Reviva’s Complete Drop-In engines are 100% dyno tested prior to shipment. Computer controls ensure that each engine dyno test is conducted under standard, repeatable settings. Every engine is run through a warm up cycle, three separate segments simulating light, medium, and heavy throttle conditions; maximum torque and horsepower tests; both high and low idle tests; and a black light leak detection test with dyed oil, coolant, and fuel.
DROP-IN ENGINE INCLUDES:
- Block
- Camshaft
- Timing gears
- Lifters
- Piston cooling tubes
- Valve train
- Oil pan & pickup tube
- Oil cooler
- Water pump
- Valve covers
- Crankshaft
- Pistons/rings
- Connecting rods
- Main/rod bearings
- Cam bearings
- Cylinder heads/valves
- Cylinder Head-Stud Upgrade
- Oil pump
- Front cover
- Rear cover/flywheel housing
- Oil filter canister
- Injectors
- Glow plugs
- High pressure oil pump
- Crankshaft position sensor
- Engine oil pressure sensor
- EOT - Engine oil temperature sensor
- ICP - Injection control pressure sensor
- High pressure oil rails
- Vibration damper
- Injection pressure regulator valve
- Camshaft positioning sensor
- Intake manifold
- Turbo exhaust piping
- Bullet Proof EGR Cooler
- EGR valves
- Intake air temperature sensor
- Intake air pressure sensor
- Exhaust back pressure sensor
- Exhaust manifold
- Turbocharger
- Dipstick tube & dipstick
IMPORTANT INSTALLATION INFORMATION
EGR Cooler must be tested and/or replaced to activate warranty on all Long Blocks and Long Block Supremes.
