Industrial Injection - 20% Over RACE1 100HP Factory OEM Reman Injector - 2001-2004 GM 6.6L LB7 Duramax 0986435502-R1

Part # 0986435502-R1

The Industrial Injection 20% over Race 1 Injectors start out as a genuine stock remanufactured injector from the factory then have been extrude honed and balanced to a perfect matching set injectors that flow 24LPM. The Race 1 20% over injectors work great in a completely stock truck as well as one that has been modified with tuning and or turbo upgrades. We typically see a 1-3MPG increase in fuel economy. This is a 100% Bosch Reman Injector directly from Bosch themselves simply sold and modified by us here at Industrial Injection.

FEATURES:

     - Performance Injector

     - Better Fuel Economy

     - 20% over / 24LPM

     - 1 year Unlimited Mileage Warranty

These injectors come with a new copper crush washer and o-rings for installation. Injectors are an OEM Genuine part that is a direct replacement injector. 

Each injector has a core charge which is fully refundable if your old injector is shipped back within 45 days.

All Industrial Injection / OEM products are covered by a one year/unlimited mile warranty.

When replacing the injectors in your LB7 Duramax we highly recommend replacing the injector fuel lines to avoid new injector contamination. The most common failure of new injector installations is contamination and the problem that we see most on these comes from the fuel lines. 

NOTE: Fuel Lines MUST be replaced or cleaned professionally before installation to retain warranty!

You may have noticed that there are two types of remanufactured injectors that Industrial Injection offers ~ Either "Factory Reman" or "II Reman".

Factory Re-manufactured means that a Genuine Bosch re-manufactured stock injector is used as the base injector and then a freshly extruded/honed Industrial Injection nozzle is installed and calibrated to give you your desired percentage/HP over stock.

II or Industrial Injection Reman means that Industrial Injection uses the cores that are available to them or you send in your old injectors to rebuild. They then install their nozzles and calibrate to achieve your requested HP gains. They usually have plenty of cores to rebuild but sometimes will require you to send in yours to rebuild. The part numbers for those injectors are denoted with an "SE" near the end. If you are interested in having them rebuild your injectors this is a great way to have them done and bypass having to pay a core charge. Contact us on our toll free 1(800)823-4444 to check availability or arrange a rebuild!

LPM - Sometimes a rating of LPM is shown in the description of an injector or nozzle. LPM stands for Liters Per Minute. This is just the rating to show the highest potential flow at full fuel pressure and open throttle.