Yukon Bearing Install Kit For 2010 And Down GM And Chrysler 11.5 Inch BK GM11.5

Part # BK GM11.5

Yukon Bearing installation kits are perfect for shops and builders who have shims on the shelf and are looking to save cost over a Master Overhaul kit. This kit uses Timken bearings and races along with all high quality small parts. Yukon does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your ring and pinion set.

• Yukon Bearing install kit for 2010 and down GM and Chrysler 11.5 inch differential
• Fits 2010 and down GM and Chrysler 11.5 inch
• Included are carrier bearings and races, Pinion Bearings and races, pinion seal, crush sleeve, marking compound and brush
• 1 Year Warranty Against Manufacturer Defects
• Sold As A Kit

Technical Notes:

• In mid 2011 the design for the Pinion Bearing changed.
• The early design had a rear pinion race O.D. of 4.125 inch.
• The later design has an O.D. of 4.375 inch. This kit is the 4.125 inch design.

• Chevrolet Silverado 2500 3/4 Ton (2001 - 2010)
• Chevrolet Silverado 3500 1 Ton (2001 - 2010)
• Chevrolet Silverado HD 2500 3/4 Ton (2001 - 2010)
• Chevrolet Silverado HD 3500 1 Ton (2001 - 2010)
• Dodge Ram 2500 3/4 Ton (2003 - 2010)
• Dodge Ram 3500 1 Ton (2003 - 2010)
• Dodge Ram Van 2500 3/4 Ton (2003 - 2003)
• GMC Sierra 2500 3/4 Ton (2001 - 2010)
• GMC Sierra 2500 HD 3/4 Ton (2001 - 2010)
• GMC Sierra 3500 1 Ton (2001 - 2010)
• GMC Sierra 3500 HD 1 Ton (2001 - 2010)